标题：Confiabilidad entre instrumentos (T-Force® y Myotest®) en la valoración de la fuerza. (Inter-machine Reliability (T-Force® y Myotest®) in strength assessment).
期刊名称：RICYDE. Revista Internacional de Ciencias del Deporte. doi:10.5232/ricyde
印刷版ISSN：1885-3137
出版年度：2012
卷号：8
期号：27
页码：20-30
语种：
出版社：Ramón Cantó Alcaraz (Publisher)
摘要：El estudio pretende caracterizar la confiabilidad entre dos instrumentos, medidor de posicionamiento lineal (MPL, dinamómetro inercial T-Force) y el acelerómetro (AC) 3-D (Myotest Sport, modelo S4P), habituales en la medición de variables de rendimiento. Fueron analizados 40 ensayos en la realización del ejercicio press banca (25 kg) en fase concéntrica a la máxima velocidad por tres sujetos (26.74 ± 1.2 años, 175.74 ± 4.04 cm, 78.7 ± 3.35 kg). Las variables analizadas fueron velocidad máxima, fuerza máxima estimada y pico de potencia estimado. Ambos aparatos obtuvieron los datos simultáneamente. Se desarrollaron tres modelos de regresión lineal simple proporcionados por el medidor de posicionamiento lineal (MPL) a partir de los datos del acelerómetro (AC). Se contrastó el supuesto de independencia de los errores mediante la prueba de Durbin-Watson. Se calcularon autocorrelaciones parciales para un nivel de significación p<.05. No ha sido posible confirmar la existencia general de correlaciones entre las medidas de ambos aparatos. Los datos estuvieron caracterizados por una autocorrelación generalizada y se recomienda la utilización de estrategias que contemplen el control del error producido por el factor de dependencia de los datos cuando se miden deportistas. Sólo se encontró correlación entre aparatos en unos de los casos no concluyentes, variable (Pico de Potencia) y sujeto 1, r(10) = .64, p = .024. No se encontraron autocorrelaciones parciales. AC obtiene mayores valores promedio y de dispersión que MPL. Los resultados evidencian probabilidad de aumento del valor de la incertidumbre de la medida en AC conforme a las orientaciones especificadas en Metrología. Ambos aparatos no deberían usarse indistintamente en la evaluación y control del entrenamiento. Palabras Claves : entrenamiento de fuerza; press banca; metrología. Abstract The purpose of this study was to determine the inter-machine reliability of two devices routinely used to measure variables in sports performance: the linear position measuring device (LPM, isoinertial dynamometer T-Force) and the (AC) 3-D accelerometer (Myotest Sport, S4P model). 40 bench press exercises (25 kg) were analysed at concentric contraction phase and at maximum velocity, carried out by three different subjects (age: 26.74 ± 1.2 years, height: 175.74 ± 4.04 cm, weight: 78.7 ± 3.35 kg). Variables analysed comprised maximum velocity, maximum estimated force and estimated peak power. The data from both devices was collected simultaneously. Three simple lineal regression models were developed, supplied by the linear position measuring device (LPM) on the basis of the accelerometer’s (AC) data. The assumption of independence of errors was compared by means of the Durbin-Watson test. Partial autocorrelation coefficients were calculated for a p<.05 significance level. It has not been possible to confirm the presence of a general correlation between the measurements of both devices. The data was characterised by a generalised autocorrelation and it is recommended that strategies reflecting error control resulting from the data dependence factor be applied when measuring an athlete’s performance. An inter-machine correlation was only found in one of the non conclusive cases: (Peak Power) variable and subject 1, r(10) = .64, p = .024. No partial autocorrelation was found. The AC device obtained higher average and dispersion values than the LPM device. The results show the probability of an increase to the value of uncertainty of the AC device measurements in accordance with Metrology specified guidelines. Both devices should not be used interchangeably when assessing and monitoring training. Key words : resistance training; bench press; metrology. doi:10.5232/ricyde2012.02702 --------------------------------------------------------------------- Referencias/references Casartelli, N.; Müller, R., & Maffiuletti, N. (2011) Validity and reliability of the Myotest accelerometric system for the assessment of vertical jump height. Journal of Strength and Conditioning Research, 24(11), 3186–3193. http://dx.doi.org/10.1519/JSC.0b013e3181d8595c PMid:20940642 Cohen, J. (1992). A power primer. Psychological Bulletin, 112, 155-159. http://dx.doi.org/10.1037/0033-2909.112.1.155 PMid:19565683 Earnest, C.; Wharton, R.; Church, T., & Lucia, A. (2005) Reliability of the lode Excalibur sport ergometer and applicability to Computrainer electromagnetically braked cycling training device. Journal of Strength and Conditioning Research, 19(2), 344–348 PMid:15903373 El Hage, R.; Zakhem, E.; Moussa, E., & Jacob C. (2011) Acute effects of heavy-load squats on consecutive vertical jump Performance. Science & Sports 26, 44—47 http://dx.doi.org/10.1016/j.scispo.2010.08.006 Esliger, D.W., & Tremblay, M.S. (2006) Technical reliability assessment of three accelerometer models in a mechanical setup. Medicine & Science in Sports & Exercise, 38, 12, 2173-2181. http://dx.doi.org/10.1249/01.mss.0000239394.55461.08 Gonzalez-Badillo, J.J., & Sanchez-Medina, L. (2010) Movement Velocity as a Measure of Loading Intensity in Resistance Training. Int J Sports Med 2010; 31: 347– 352. http://dx.doi.org/10.1055/s-0030-1248333 PMid:20180176 Jidovtseff, B.; Crielaard, J.M.; Cauchy, S., & Croisier, J.L. (2008) Validity and reliability of an inertial dynamometer using accelerometry. Science & Sports, 23, 94–97 http://dx.doi.org/10.1016/j.scispo.2007.12.012 Welk, GJ.; Schaben, J.A., & Morrow J.R. (2004) Reliability of accelerometry-based activity Monitors: a generalizability study. Medicine & Science in Sports & Exercise, 36, 9, 1637-1645. PMid:15354049
