摘要：Industrial in-series aluminum castings contain a wide range of microstructural heterogeneities like differences in secondary dendrite arm spacing (SDAS), eutectic silicon and intermetallic precipitates of varying morphologies and diverse-shaped and-sized porosity. Regarding to technical and economic limitations, the complete elimination of them is hard to achieve, which requires conservative design, i.e., increased wall thicknesses to accommodate the failure tolerance. To improve the performance of cast aluminum products concerning safety and fatigue properties, the present work deals with the significance of such structures with respect to the threshold for crack propagation ΔKI,thunder pure bending and the fatigue behaviour in the high-and very-high-cycle-fatigue regime (HCF and VHCF). Therefore, two automotive cast alloys taken from engine blocks (AlSi8Cu3) and cylinder heads (AlSi7Cu0.5Mg) and a gravity die cast set (AlSi7Mg0.3), either T6 conditioned or additionally hot isostatic pressed (HIP), were used. For in-series castings, two positions of maximal difference in cooling rate and respective microstructure were extracted. With this set of specimens, the significance of SDAS in interaction with (i) eutectic silicon regions, (ii) intermetallic precipitates in varying occurrence, (iii) the crystallographic orientation, and (iv) the porosity in correlation with the fatigue threshold is shown and compared with first results of fatigue damaging mechanisms in quasi pore-free material.
