摘要：In reversible data hiding, pixel value ordering is an up-to-the-minute research idea in the field of data hiding. Secret messages are embedded in the maximum or the minimum value among the pixels in a block. Pixel value ordering helps identify the embeddable pixels in a block but suffers from fewer embedding payloads. It leaves many pixels in a block without implanting any bits there. The proposed scheme in this paper resolved that problem by allowing every pixel to conceive data bits. The method partitioned the image pixels in blocks of size two. In each block, it first orders these two pixels and then measures the average value. The average value is placed in the middle of these two pixels. Thus, the scheme extends the block size from two to three. After applying the embedding method of Weng et al., the implantation task removed the average value from the block to reduce its size again to two. These two alive pixels are called stego pixels, which produced a stego image. A piece of state information is produced during implanting to track whether a change is happening to the block’s cover pixels. This way, after embedding in all blocks, a binary stream of state information is produced, which has later been converted to decimal values. Thus, image data were assembled in a two-dimensional array. Considering the array as another image plane, Weng et al.’s method is again applied to embed further to produce another stego image. Model validation ensured that the proposed method performed better than previous work in this field.
关键词：Reversible Data Hiding;Stego Image;Multilayer Embedding;Block Partition;Embedding Payload
