期刊名称：Advances in Science and Technology Research Journal
印刷版ISSN：2080-4075
电子版ISSN：2299-8624
出版年度：2021
卷号：15
期号：4
页码：49-60
DOI：10.12913/22998624/141935
语种：English
出版社：Society of Polish Mechanical Engineers and Technicians
摘要：The description of the characteristics of the surface using standardized roughness parameters can not fully predict its performance properties. One of the tools supporting the assessment of the surface layer of the treated surface may be fractal analysis. This applies both to surfaces with machining traces, which are created under conditions of high randomness and variability of process conditions, and to surfaces with directional traces and their distinct periodicity. The paper presents the results of surface roughness measurements of turned aluminium matrix composites reinforced with ceramic fi bers. Carbide and diamond tools were used for turning the tested material. The trials were carried out under dry machining conditions and with minimal lubrication in the cutting zone. Surfaces were measured by the contact method, and surface roughness parameters were calculated by Ga ussian fi ltration. Then, the values of the fractal dimension were calculated using the enclosing box method. On the basis of these calculations, the infl uence of machining conditions on the values of selected roughness parameters and the box fractal dimension was determined. It was found that the fractal dimension, i.e. the irregularity of the geometric structure of the surface after turning of composites, changes with the change of cutting parameters, the tool and the method of lubricating the cutting zone. Of these factors, the feed has the greatest infl uence. As it grows, the irregularity of the machined surface structure decreases. In addition, the correlation coeffi cients between the fractal dimension and the measured roughness parameters were determined. It was noticed that the fractal dimension, in the case of turning aluminum composites, best correlates with the roughness parameters Sa and Ssk and thus describes features similar to these parameters. Therefore, it was assumed that it is possible to use fractal analysis as a supplementary tool for the description of the surface condition of aluminum composites after turning in various machining conditions. On the other hand, the fractal dimension can be treated as an additional tool to describe the surface condition, especially its irregularity, which is not described by other standard roughness parameters.
关键词：fractal analysis;surface roughness;composite materials;cutting zone lubrication;diamond
