期刊名称：Eastern-European Journal of Enterprise Technologies
印刷版ISSN：1729-3774
电子版ISSN：1729-4061
出版年度：2019
卷号：3
期号：1
页码：42-48
DOI：10.15587/1729-4061.2019.167077
语种：English
出版社：PC Technology Center
摘要：A broaching technique for thick-walled pipes has been investigated. The proposed technique implies the deformation of a hollow workpiece without a mandrel. The procedure has been devised to conduct theoretical studies using FEM. The procedure is aimed at determining the thermal, stressed state and a shape change in the workpiece while forging pipes without the use of a mandrel. The variables applied were the internal diameter of a hollow workpiece, which ranged in the interval of 0.30; 0.55; 0.80. Based on the finite-element modeling, the following was established: the distribution of temperatures and intensity of logarithmic deformations within the volume of a pipe after broaching without the use of a mandrel. The diameter of a pipe’s hole has been determined, which is formed at broaching when applying a given technique. The dependences of intensity of lengthening and thickening of the wall of a pipe have been established. A special indicator was devised to estimate the elongation rate of a pipe. It was determined that increasing the inner diameter increases the lengthening of a pipe and decreases the intensity of the hole forging. The common dependence for the simulated broaching schemes is that the magnitude of elongation of a hollow workpiece changes insignificantly for different degrees of reductions at constant relative sizes of a pipe. It has made it possible to establish a recommended feed in order to increase the elongation of a hollow forging and to decrease the degree of closing a hole. The rational feed shall be (0.05...0.15)D. The results from the finite element modeling were verified by experimental study using lead samples. An experimental modeling procedure has been devised. It was established that at an inside diameter of the workpiece of (0.5...0.6)D one observes a maximum of the wall thickening. It was established that the results for a workpiece shape change, obtained from a theoretical study using FEM, exceeded those acquired experimentally by 9.14 %. The validity of results from theoretical modelling is confirmed by data from experiments on decreasing the internal diameter of the pipe. Difference between the theoretical and experimental results amounts to 9...12 %. The established patterns make it possible to determine the resulting diameter of a pipe’s hole. It was found based on the results from modeling that it is impossible to broach pipe workpieces without a mandrel. This technique extends the possibilities of technological processes aimed at manufacturing pipe workpieces.
关键词：thick-walled pipe;broaching without a mandrel;forging;forge a hole;workpiece lengthening;FEM;thermal state;strained state.
