摘要：Dual-stage standalone photovoltaic (PV) systems suffer from stability, reliability issues, and their efficiency to deliver maximum power is greatly affected by changing environmental conditions. A hybrid back-stepping control (BSC) is a good candidate for maximum power point tracking (MPPT) however, there are eminent steady-state oscillations in the PV output due to BSC’s recursive nature. The issue can be addressed by proposing a hybrid integral back-stepping control (IBSC) algorithm where the proposed integral action significantly reduces the steady-state oscillations in the PV array output under varying temperature and solar irradiance level. Simultaneously, at the AC stage, the primary challenge is to reduce both the steady-state tracking error and total harmonic distortion (THD) at the output of VSI, resulting from the load parameter variations. Although the conventional sliding mode control (SMC) is robust to parameter variations, however, it is discontinuous in nature and inherit over-conservative gain design. In order to address this issue, a dynamic disturbance rejection strategy based on super twisting control (STC) has been proposed where a higher order sliding mode observer is designed to estimate the effect of load disturbances as a lumped parameter which is then rejected by the newly designed control law to achieve the desired VSI tracking performance. The proposed control strategy has been validated via MATLAB Simulink where the system reaches the steady-state in 0.005 s and gives a DC–DC conversion efficiency of 99.85% at the peak solar irradiation level. The AC stage steady-state error is minimized to 0 V whereas, THD is limited to 0.07% and 0.11% for linear and non-linear loads, respectively.
