期刊名称：IOP Conference Series: Earth and Environmental Science
印刷版ISSN：1755-1307
电子版ISSN：1755-1315
出版年度：2019
卷号：295
期号：3
页码：1-8
DOI：10.1088/1755-1315/295/3/032032
出版社：IOP Publishing
摘要：To verify the correctness of the sample quality and the finite element model, optical measurement technology is applied in this study. Unable to consider the quality of tack welding during the established modeling, a three-dimensional scanner is used to detect box complex structures after welding. The finite element model of box structure is established for the study of welding deformation of box structure with short, multi space and multi staggered distributed weld seam. The accuracy of the model is verified by global detection of the structural parts. The results show that the deformation trend warps at the boundary of the left and right plate and concaves in the center of the plate. The maximum deformation of the vertical plate center is 1.714mm. The bottom pad produces the extruding tendency, and the deformation near two sides of the plate is about 0.51mm, which is greater than that of 0.34mm away from the two sides of the plate. The deformation is not consistent in the front and back sides of the Z plate. The maximum error of the sample parts takes place in the front Z shape plate with an error of - 0.03mm~0.12mm. There is a certain size difference under the influence of the welding gap, but it still meets the requirements of the engineering application to eliminate the influence of the welding quality on the deformation measurement. By comparing the results of the simulation and the global measurement of the structural parts, the difference between the vibration seat and the front Z plate has a large difference that is 0.12mm~0.24mm, and the deviation satisfies the requirements of the engineering application, and it can effectively guide the production.
