摘要：The energy efficiency of air-to-water heat pump operating in an actual heating installation depends on many factors. In order to create a reliable model of the unit, it is necessary to include as many of them as possible. Unfortunately, the most common data provided by heat pump manufacturers are based on tests performed in accordance with the EN 14511 standard [1]. These tests are performed in steady-state conditions and do not provide reliable information on the impact of dynamic effects on the energy efficiency of the device. The solution may be the tests in quasi-dynamic conditions. The article presents the possibility of creating the characteristics of an air-to-water heat pumps based on operational data. The accuracy of the created model has been compared with the characteristics resulting from measurements in steady state conditions. It has been confirmed that dynamic test data, after proper selection, will allow to determine the characteristics of repeatable parameters and this can be an alternative to tests performed in fixed conditions.
其他摘要：The energy efficiency of air-to-water heat pump operating in an actual heating installation depends on many factors. In order to create a reliable model of the unit, it is necessary to include as many of them as possible. Unfortunately, the most common data provided by heat pump manufacturers are based on tests performed in accordance with the EN 14511 standard [1]. These tests are performed in steady-state conditions and do not provide reliable information on the impact of dynamic effects on the energy efficiency of the device. The solution may be the tests in quasi-dynamic conditions. The article presents the possibility of creating the characteristics of an air-to-water heat pumps based on operational data. The accuracy of the created model has been compared with the characteristics resulting from measurements in steady state conditions. It has been confirmed that dynamic test data, after proper selection, will allow to determine the characteristics of repeatable parameters and this can be an alternative to tests performed in fixed conditions.
