摘要：The article presents the analysis of the automatic control of the bioethanol production process intended for biofuel. It presents the formulated general concept of the system and the method of designing a closed control system based on the iterative prototyping procedure. The modeling and the simulation were carried out in the Matlab®-Simulink environment. The simulation model of the object was developed based on the experimentally registered characteristics. It has been adjusted, i.e. the compatibility of its behavior with the object it reproduces has been confirmed. Based on the tuned model of the object, a control system model was created, which was the basis for computer simulation which enabled the control algorithm parameters to be established. The final verification of the correct operation of the system was performed with the use of hardware simulation. It was based on entering a negative feedback loop of the virtual control system of the real object elements into the loop. The results of the simulation confirmed the correctness of the adopted design.
其他摘要：The article presents the analysis of the automatic control of the bioethanol production process intended for biofuel. It presents the formulated general concept of the system and the method of designing a closed control system based on the iterative prototyping procedure. The modeling and the simulation were carried out in the Matlab®-Simulink environment. The simulation model of the object was developed based on the experimentally registered characteristics. It has been adjusted, i.e. the compatibility of its behavior with the object it reproduces has been confirmed. Based on the tuned model of the object, a control system model was created, which was the basis for computer simulation which enabled the control algorithm parameters to be established. The final verification of the correct operation of the system was performed with the use of hardware simulation. It was based on entering a negative feedback loop of the virtual control system of the real object elements into the loop. The results of the simulation confirmed the correctness of the adopted design.
