标题：Volcanic ash in bare ice south of Sør Rondane Mountains, Antarctica: geochemistry, rock magnetism and nondestructive magnetic detection with SQUID gradiometer
摘要：Nondestructive magnetic detection of tephra layers in ice cores will be an important method to identify and correlate stratigraphic horizons of ice bearing volcanic ash particles.Volcanic ash particles were extracted from tephra-bearing ice samples collected from Nansen Ice Field south of the Sør Rondane Mountains, Antarctica.Particles are fresh glassy volcanic ash with diameters of ~50 μm, and chemical composition of the matrix glass belongs to a low-K basaltic andesite group, ranging from SiO2 60–62 wt% and K2O 0.40–0.50 wt%.Considering the grain size of ash particles and chemical composition of volcanic glass, the ash in tephra-bearing ice samples might be originated from the South Sandwich Islands located 2800 km northwest of the sampling sites.Correlations on major element concentrations with tephra layers associated with South Sandwich Islands in EPICA-Dome C, Vostok, and Dome Fuji ice cores show high similarity.Rock magnetic experiments show that the magnetic mineral is pseudo-single-domain titanomagnetite with ulvospinel content of 0.2–0.35 mixed with single-domain to superparamagnetic (titano)magnetite.Small blocks of the tephra-bering ice were measured with a SQUID gradiometer at 1-mm intervals with a spatial resolution of ~3 mm.With DC magnetic field of 25 mT, magnetic signal could be enhanced and detected for all the samples including the one with invisible amount of tephra particles.In order to simulate a thin ash layer in ice core, volcanic ash particles extracted from the tephra-bearing ice were used to fabricate a thin ash layer, which were subsequently magnetized, measured with the gradiometer.The noise level for Z axis gradiometer was about 0.6 pT.Detection limit for a half-cylinder with 29 mm radius and a thickness of 1 mm uniformly magnetized in X axis direction is ~9 × 10−5 A/m, which could be improved down to ~2 × 10−6 A/m by reducing the sensor-to-sample distance to 0.5 mm.
