摘要：The article presents the calculation and design stages of the TLP platform serving as a supporting construction of a 6 MW offshore wind turbine.This platform is designed to anchor at sea at a depth of 60 m.The authors presented the method of parameterization and optimization of the hull geometry.For the two selected geometry variants,the load and motion calculations of the platform subjected to wind,wave and current under 50-year storm conditions were performed.The maximum load on the structure was determined in these extreme storm conditions.For these loads,the MES calculation of the designed platform was performed for the selected variant.Authors have presented a method for calculating maximum wind,wave and current stresses on the structure during the worst storm in the past 50 years.For these loads the MES endurance calculations of the designed platform were made.Based on the results of these calculations,the required structural changes and recalculations have been made in succession to the structural design of the platform,which meets the design requirements and has the required ad hoc strength.The article contains stress analysis in „difficult” nodes of constructions and discusses ways of solving their problems.The work is part of the WIND-TU-PLA project from the NCBR Research Agreement (Agreement No.MARTECII / 1/2014).
