摘要：The aim of this study was to determine the effect of the support phase composition (Al 2 O 3 –TiO 2 ) and the addition of gold on the catalytic properties in low-temperature CO oxidation. In this paper, the physicochemical properties and results of catalytic measurements performed for the obtained samples were investigated. The catalyst carriers were prepared using the sol-gel method with alkoxide Al(C 3 H 7 O) 3 and Ti(C 3 H 7 O) 4 employed to obtain the corresponding oxides, in the case of which the molar ratio (Al 2 O 3 :TiO 2 ) was 0.75:0.25, 0.50:0.50 and 0.25:0.75, thus corresponding to the molar ratio of the Al:Ti elements, i.e. 1.5:0.25, 2:1 and 0.5:0.75 respectively. The gold catalysts were prepared through the deposition of gold by the deposition precipitation method using the theoretical loading of Au 2 wt.%. To examine the effect of the phase composition on the catalytic activity of the obtained samples, appropriate carriers were calcined at two different temperatures: 500°C and 1350°C. This made it possible to obtain the intended polymorphs of aluminum oxide and titanium dioxide (γ–Al 2 O 3 , α–Al 2 O 3 , anatase and rutile). For certain samples, calcined at a high temperature, the aluminum titanium oxide (Al 2 O 5 Ti) phase was also observed. The prepared samples were characterized by XRD, BET, SEM, and additionally both particle size distribution analysis and measurements of the catalytic activity were performed. The highest catalytic activity was shown by Au/75Al–25Ti_LT, where T 90 was about 110°C.
