摘要：The repeated normal elastic plastic contact problem of a deformable sphere against a rigid flat under full stick contact condition is investigated with a commercial finite element software ANSYS. Emphasis is placed on the effect of strain hardening and hardening model with the maximum interference of load ranging from elastic to fully plastic, which has not yet been reported. Different values of tangent modulus coupled with isotropic and kinematic hardening models are considered to study their influence on contact parameters. Up to ten normal loading-unloading cycles are applied with a maximum interference of 200 times the interference required to initiate yielding. Results for the variation of mean contact pressure, contact load, residual interference, and contact area with the increasing number of loading unloading cycles at high hardening parameter as well as for low tangent modulus with two different hardening models are presented. Results are compared with available finite element simulations and in situ results reported in the literature. It is found that small variation of tangent modulus results in same shakedown behavior and similar interfacial parameters in repeated loading-unloading with both the hardening rules. However at high tangent modulus, the strain hardening and hardening rules have strong influence on contact parameters.
